
- 19 –
WebEye SPD User’s Guide
•
Single Shot Mode : If you choose the mode and click the start button, only one frame of image
is transferred. Therefore, no other images may be viewed. To go back to the real-time images,
just click the button again
Resolution: User may select a level of resolution among 5 levels (720x486, 720x243, 360x243,
180x121, 90x60). High-resolution image is big, and it is transmitted at slow speed.
Frame Rate: You can choose the transmission speed. If you choose ‘Fastest’, you can get images at
fastest speed. The transmission speed depends much on network line’s capacity and user PC’s
performance.
(3) Pan/Tilt/Preset Control
Pan/Tilt: Locate your mouse cursor on the control panel and keep
pressing the left button of mouse, then you can move the direction of
WebEye to where you want to see. The nearer location from the center
of the panel you click, the less WebEye SPD moves. While the further
location you click on the panel, the more WebEye moves. You just
release your finger from the mouse to stop moving.
Zoom: You can zoom in/out the image with dragging the ball on the
vertical bar ‘T’, ‘W’ of control panel.
Auto-Focus: Basically, WebEye SPD has auto-focus function. However, you can control and
optimize the focus of image manually.
Preset : WebEye SPD has 64point preset function. If you
preset a point, the cam The preset Dialog Box will be
activated. Then your selection to a certain point on the list
will make the cam move to the reserved point.
Take/Give Control
: By clicking this button, user get
operation right of pan/tilt/zoom/preset function(Take
Control) or hands it over to another person(Give Control).
In the case that one user takes the control right, new user
may have to wait until the first user finish the PTZ
operation.
•
Theses functions will be explained in detail at chapter VI….
Comentários a estes Manuais